You are currently viewing How To Remove Hair From Drain?

How To Remove Hair From Drain?

  • Post category:Hair
  • Post last modified:May 10, 2023
  • Reading time:13 mins read

To remove hair from a drain, start by using a pair of needle-nose pliers to pull out any clumps of visible hair. If this doesn’t work, then try pouring boiling water down the drain or use a homemade mixture of baking soda and vinegar. You can also make an easy snake by tying several rubber bands together to form a long loop.

Lower the snake into the drain and twist it around until you feel resistance, which indicates that the hairs have been snagged on the rubber loops. Once those are cleared out, pour more hot water down your drain to flush away any remaining debris before running cold water for at least 30 seconds.

  • Gather Supplies: Before attempting to remove hair from a drain, you will need to gather some supplies such as rubber gloves, a cup plunger, a bottle brush and some non-caustic cleaning products.
  • Prepare the Drain: Begin by running hot water down the drain for several minutes in order to loosen any clumps that may be forming due to the accumulation of soap scum and grease. This will also make it easier for you to unclog the pipe with your plunger or bottle brush later on.
  • Use Plunger or Bottle Brush : Insert either your cup plunger or your bottle brush into the drain opening and begin pushing it up and down vigorously until any blockages are removed. Make sure not to push too hard as this can cause damage to both your pipes and fixtures! After completing this step, run hot water down again for another few minutes in order for anything remaining in there (i, hair) to be flushed out completely.
  • Clean Out Pipe: Using non-caustic cleaners like baking soda or vinegar mixed with warm water, pour slowly into the drain while gently scrubbing away at any stubborn spots within it; this should help dislodge any remaining debris such as hair which was unable to be removed during previous steps.
  • Rinse & Dry : Finally, once all of these steps have been completed then rinse out thoroughly with plain hot water before drying off so no moisture is left behind ; if possible leave open overnight allowing air circulation around area which helps prevent mold/mildew growth.

How to Get Hair Out of Bathtub Drain?

To get hair out of a bathtub drain, you can use a specially designed tool called a drain snake. This tool is made to fit into the narrow opening of most drains and has small hooks at one end which are used to grab onto any clumps of hair that may be blocking the flow. Alternatively, you can put equal parts baking soda and vinegar down the drain followed by boiling water.

The mixture will help loosen up any debris in the pipes so it can be washed away with hot water.

How To Remove Hair From Drain?


What Will Dissolve Hair in a Drain?

There are many products on the market that claim to dissolve hair in a drain, however not all of them work as effectively as they say. The most effective way to dissolve hair is by using an enzyme-based product. These enzymes work by breaking down the proteins in hair into smaller molecules which can then be easily flushed away with water.

Some of these enzymatic drain cleaners also contain surfactants which help break up the clumps of hair and make it easier for it to flow through your pipes. For stubborn cases, you may need to use a combination of hot water and vinegar or baking soda to help loosen the hairs from your drain pipes before using an enzyme-based product for maximum effectiveness.

How Do You Remove Hair from a Sink Drain?

Removing hair from a sink drain is an annoying but necessary task. The first step is to get rid of any surface debris in the drain or surrounding area. You can do this by using a plunger, auger, or snake.

Once you’ve cleared out all the debris and gunk on the surface, it’s time to tackle the hair that has built up inside your sink’s pipes. The best way to remove hair from a sink drain is with boiling water; simply fill up your kitchen kettle and pour it down into your plug hole directly after unblocking with either a plunger, auger or snake if needed. This should help dislodge most of the stubbornly stuck-on hairs which have become tangled around other particles in your pipes.

If there are still some hairs left behind that won’t budge with hot water then try using an old toothbrush dipped in white vinegar and baking soda – these ingredients combined create a powerful reaction when mixed together which will break apart any remaining blockages caused by trapped hairs! Finally use plenty of warm soapy water afterwards to flush away any residue before replacing the plug back onto its rightful place – job done!

How Do You Remove Hair from a Bathtub Drain?

If you’ve ever had long hair, you know it can be a hassle to keep it from clogging up your bathtub drain. Hair is one of the most common culprits when it comes to slow-draining or clogged drains, and if not dealt with properly, can cause serious damage to pipes over time. Luckily there are some simple steps that you can take in order to remove hair from your bathtub drain quickly and easily.

First, use either an old toothbrush or a bent wire hanger to reach into the drain and pull out as much hair as possible. This should break off any larger chunks of trapped material that may have been causing the obstruction. Once this has been done, pour boiling water down the drain followed by some dish soap; this will help dissolve any remaining residue while also providing lubrication for more difficult obstructions further down the line.

Finally try using a plunger on both sides of the drain – pushing one side down at a time – which will often provide enough suction power to remove even stubborn accumulations of debris like hairballs or wads of tangled strands. With these tips in mind, you’ll never again have worry about troublesome tub drains!

How Do I Get Rid of Hair Build Up in My Shower Drain?

If you’ve noticed that your shower drain is becoming clogged due to hair build up, there are a few steps you can take to get rid of it. First and foremost, pour boiling hot water down the drain as often as possible. This will help break up any large chunks of hair and soap scum that have accumulated in the pipe.

Additionally, use a plunger or plumber’s snake if necessary to loosen any particularly stubborn blockages in the pipes. For regular maintenance, put screens over all your drains so that the small strands of hair don’t make their way into them in the first place; this will also help keep out other debris like dirt and sand. If all else fails you may need to hire a professional plumber who can inspect your pipes with specialized tools such as cameras or augers.

No matter what method you choose though, regular cleaning is key when it comes to keeping your shower drains clear from nasty hair buildup!

How To Remove Hair From The Drain With A Hanger


By following the steps outlined in this blog post, you can safely and effectively remove hair from a clogged drain. With just a few simple tools, including a pair of rubber gloves, pliers or tweezers, baking soda and vinegar solution, and boiling water, you will be able to clear out any clogs caused by hair buildup in your drain. Remember to always use caution when dealing with drains as they contain hazardous materials.

By taking proper precautions and using the right techniques for removing hair from drains, you can ensure that your plumbing is working properly again in no time!